Before Start Print and install PrintParts to ensure accurate measurement. Tension calculation table of Belter value-tension converters to assist users in converting readings into belt tension (N). Before start make sure download the Single-Hand Operation Model and Tension Calculator table Installing Panda Touch Use the hex/allen key and the two M3x6 FHCS to assemble the Charging Dock and the Mounting Bracket as shown. Peel off the film from the bottom side of the Mounting Bracket. Ensure the printer surface is clean and free of oil, grease, etc., attach the assembled Charging Dock centrally atop the original screen. Apply pressure to adhere fully and allow 12 hours for optimal adhesion. Attach the Panda Touch to the Charging Dock. Wiring and Power Connection Remove the foam ... Dimension Diagram The coil's center point, used for calculating XY offsets, is as follows: Location of the BOOT Button The BOOT button is used when programming Klipper onto the Eddy for the first time; afterward, Klipper can automatically reprogram the RP2040. Note:Only Eddy V1.0 has the BOOT function; the button on Eddy Coil V1.0 is non-functional. Installation Guide Installation Height Install Eddy 2 to 3 mm above the nozzle to ensure optimal performance. If you encounter any errors during ... To see the group profile, click here. For the members solo profiles, click here. For units and pairings, click here and here.
